Outdoor flying spaceship project instructions.
Full Instructions for this Halloween Geek Project
By: Chris Olsen

Instructions for a double Axworthy setup without trees.
Full Instructions for this Halloween Geek Project
By: David Llewellyn of RavenManor

Instructions for making an outdoor flying ghost.
Full Instructions for this Halloween Geek Project
By: Corey Minion

Schematic and parts list for electrical circuit that allows you to drive a servo using any audio source.
Full Instructions for this Halloween Geek Project
By: Scary Terry

Animated foam alligator prop that attacks!
Full Instructions for this Halloween Geek Project
By: Ghostmuster

Directions for building an effects controller from electrical parts.
Full Instructions for this Halloween Geek Project
By: Ian

Instructions for making a 16′ arch out of curved wood.
Full Instructions for this Halloween Geek Project
By: Haunted Lane(Mike)

In order to create the illusion that one of two corpses was leaving its grave I rigged one with a simple piston-type drive to physically lift the torso roughly 12 inches off the “grave site”, and return it, and so on. The most difficult task of this effect was getting the piston/motor set-up to […]

Have you ever wanted to build your own Animatronic? This project details how I built an animantronic using a common (around Halloween) skeleton, Hobbie Servos and and a Servo Controller Chip from FerretTronics.
Full Instructions for this Halloween Geek Project
By: Chuck Rice